Fibreglass Mouldings

About Fibreglass Mouldings

FibreGlass Mouldings was established in 1993 and having 40 years experience in the glassfibre industry is a leading composite moulding company. We specialise in the design, development and production of high quality products and services made of glassfibre reinforced polyester (GRP) referred to by some as just fibre reinforced polyester (FRP).

Canopies
Garage Roofs and Flat Window BaysFlat Roofs
Pond Linings

FibreGlass Mouldings provide a complete range of overdoor fibreglass canopies, flat roofs, garage roofs, flat roof window bays and pond linings. We carry a stock range of finishes that are extremely hardwearing and adaptable. We have an extensive line of products for you to choose from and we can even serve your bespoke needs for any custom built products.

Fibreglass (GRP) Door Canopies

We supply and fit (or supply only) a wide range of door canopies and have done for many years. Any of our products will add instant appeal and make a lasting impression to your property.

– Enhance the look of your property
– Our canopies are the professionals choice
– GRP offers a cost effective solution to weather protection
– Overdoor canopies are simple to install
– Our canopies are maintenance free, wipe with damp cloth for as new look

Canopy Fitting Instructions

– Mark out and pre-drill 6mm holes at approx 300mm centres along the canopy flanges (some canopies have a soffit & roof assembly)
– Offer canopy up to the wall and centralise it above the door opening, mark wall through pre-drilled holes
– Remove canopy and drill and plug holes and affix canopy with 60mm screws
– The gallows brackets and the large decorative legs are fixed to the wall and soffit; the small decorative legs are fixed from inside the soffit
– Cover all visible screw heads with appropriate coloured screw caps
– Clean canopy using soap and water
– Seal canopy to the wall using an appropriate colour sealer
– Care should be taken not to stand on the canopy as this may cause cracking or damage to the surface finish .

Why choose GRP / FRP products?
they enhance the look of your property
they are the professionals choicethey offer a cost effective solution to weather protection
they are maintenance free and keeps its appearance over many years to come.

FibreGlass Mouldings – Services
Glassfibre reinforced polymers (GRP) are also commonly referred to either as ‘fibreglass’ or ‘composite plastics’. Fibre reinforced polymer (FRP) composites were first developed during the 1940s, for military and aerospace applications – but considerable advances have been made since then in the use of this versatile material.

It is very strong – seven times the flexural strength of steel – yet very lightweight with the tremendous energy absorption properties that have made it a common material. NB: The flexural strength of a material is defined as its ability to resist deformation under load. For materials that deform significantly but do not break, the load at yield, typically measured at 5% deformation/strain of the outer surface, is reported as the flexural strength or flexural yield strength.

Its finish is achieved in contact with a mould surface and takes on the precise texture of that mould. Anything from the highest showroom gloss to the texture of cast iron, stone, or the finest grained wood.

We design, develop & produce high quality fibreglass products & carry out on-site installation to ensure complete satisfaction; from pattern & mould products through to installation. We offer a complete one stop service to clients.

We have undertaken a wide range of projects, both in the United Kingdom and Europe, ranging from overdoor canopies, flat roofs, garage roofs, window bays and pond linings. Amongst our other works, we have also produced race car bodies, shop fittings, truck bodies, tank linings, architectural mouldings and much more.